Did the job I needed which was to install an np205 and np435 I had to separate transfer case and transmission to use properly and needed to make some custom 2x4 jigs to make sure I didn’t have a transfer case fall on me twice.. my fault tho.. good product

Bought this to replace a fuel pump that was in the tank. Worked brilliantly to lower and raise the fuel tank.

Works good. The transmission is sliding in the steel base. If you are going to use this frequently. Gue a section of indoor/outdoor carpet on the platform. Reduces the ability of the transmission to slide on the platform. Very stiff until 7-10 inches of heighth.

Worked well. Husband was able to get his transmission out with. Have yet to use it to reinstall transmission.

Great jack, only had to install the wheels and it was ready to go.The top plate tilts up and rolls forward. Well designed and built.

Really well made. Works great! I would probably go with a hydraulic jack if you used one frequently.Best option for the money .

This made life so much easier when doing a clutch job on my car. This jack may not get a lot of use for an everyday home mechanic, but you’ll wish you had one when trying to muscle in a transmission by hand. I rated 5 stars.

worked well for dropping the transmission in my civic, it is a little tall i had to absolutely max my jack stands and it still had to roll out through the wheel well. the strap is too short to be useful so plan on swapping it with a different ratchet strap. but it seems stable enough, rolls easy, goes up and down easy, it got completely covered with atf and no issues with the paint or anything so far. would recommend.

Hubby really loves this! Said its a lot easier having the car up than tying to get under the car while it's on the ground. This really helped his attitude! Hahaha

Works really well, used to hold up transmission and transfer case when pulled the motor and everything at once together out of truck. Then disconnected trans from engine and straped it to the jack, doesnt stay up best which is unsurprising really with a 90lb transfer on end of the transmission. But having no issues at all and seems to work really well and be well built.